Design and Integration- Hardware and Software

 
Getting Started
RPC will make a proposal to do a project scope analysis on a consulting basis in order to make sure all parties understand the project costs, timeline, and deliverables; that way expectations are met or exceeded.  

 

Development and Engineering Skills
  • Electronic design including schematic capture, FPGA, ASIC
  • Electronic simulation & signal integrity
  • CAD and printed circuit board design
  • Boot code and firmware development
  • Diagnostic & network utility firmware
  • Mechanical modeling
  • Industrial design
  • Mechanical analysis including FEA, thermal, CFD, vibration
  • Product testing and validation
  • Product compliance & agency certification
  • Shipping container design and testing
 

 

Test and certification Skills
  • Design for testability
  • Custom low-level diagnostic functional test code development
  • Test Development for circuit card assembly (CCA) level, CCA panel level, module level, system level, direct fulfillment custom configuration at shipment
  • In-circuit testing (ICT)
  • Functional verification testing (FVT)
  • Environmental stress screening (ESS)
  • Environmental verification testing (EVT)
  • Mac address management
  • X-ray
  • Burn-in
  • Existing customer test network integration
 

 
   

RPC Electronics 749 Miner Road, Highland Heights, Ohio 44143 Tel 440-461-4700 Tel 800-827-2650
Copyright 2003, RPC Electronics Inc., All Rights Reserved.